Scrap 1 x 6 for the base. 2 x 3 cut to about 3 1/2 ". Small slot carved out to fit the Kreg jig. I used the kreg Jr and removed the grey sliding guides. The 2 x 3s were placed apart slightly wider than the jig itself. Screwed and glued. Cut out a small place on the base under the jig for it to slide down far enough to use the 1/2 setting. I used a piece of all thread with a knob, and glued in a nut on the opposite side. When tightened it squeezes the 2 x 3 slightly together holding the jig in place.
Clever woodworking ideas and more viewer videos
Posted by chun | | 12:04 PMLabels: and, clever, ideas, more, videos, viewer, woodworking
*****
Ed Boyle came up with this ingenious solution for a paper towel holder by cutting off the lid and threaded part of a plastic water bottle.
0 comments:
Post a Comment